Follow the on-screen instructions to complete the initial setup of Windows Server until you are prompted with the following message:. Note – The prompt is displayed in the early stages of Windows Setup and lasts for approximately five seconds and is easy to miss. Remove disks or other media. If you do not press F6 while the prompt is being displayed, the screen allowing you to specify additional drivers is not displayed and the installation will fail. Then, press any key to restart the system and complete the Windows Server Installation. Press Enter to continue.
|Date Added:||17 August 2017|
|File Size:||27.51 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Follow these steps to install the Microsoft Windows Server software onto your your server. Ensure that the floppy.
Make sure that you have completed all of the requirements listed in Installation Requirements.
Adaptec – Adaptec SATA II RAID SA
Press Enter to continue. Otherwise, press Enter to select Express Setup. If prompted with Press any key to boot from CDwindow press any key.
To Install the Operating System. Press S to specify additional devices.
IBM Support: Fix Central – Please wait, Select fixes
This chapter describes how to install the Windows Server operating system directly onto your server using the Windows Server media. Then, press any key to restart the system and complete the Windows Server Installation. Press any key to restart.
Windows Setup lists the driver to be installed. When this message appears you will need to complete one of the following steps, depending on which driver delivery method you have chosen, to complete the installation:.
At the Welcome to Setup screen, press Enter to continue. Note – The prompt is displayed in the early stages of Windows Setup and lasts for approximately five seconds and is easy to miss. If you do not press F6 while the prompt is being displayed, the screen allowing you to specify additional drivers is not displayed and the installation will fail.
Follow the on-screen instructions to complete the initial setup of Windows Server sata-li you are prompted with the following message:. Select the appropriate mass storage controller driver version depending on the version of Windows bit or bit you are installing, and then press Enter:. For requirements specific to the mass storage driver and Windows media delivery methods that you have chosen, see TABLE Windows Setup will then display your selection.
Select a setup mode Express or Custom and continue.
Connect the floppy drive to the JavaRConsole system if necessary and insert the mass-storage saga-ii floppy disk into the floppy drive. Before beginning the operating system installation, make sure that the following requirements are met. Press Adaltec when you see the following prompt at the bottom of the screen during the Windows Setup process: Install Windows Adaptev Note – The complete Microsoft Windows operating system installation process is not documented in this section.
Note that if you are using the floppy disk local installation method, the JavaRConsole floppy drive or floppy image devices must not be redirected. If you created a RAID volume on your boot disk as part of your prerequisite preparations for installing Windows, press C to select Custom Setup and manually partition the disk.
This section documents only the steps that are specific for installing Windows Server on your server. A screen appears listing the available drivers.
You will need to restart the system and go back to Step 3. Make sure that the mass storage drivers are accessible according to the mass storage driver installation method that you have selected. After pressing Das, a screen will appear providing you with the option to specify additional mass storage devices. The Windows installation will format the boot disk and all data will be lost.
Remove disks or other media. Make sure to reserve a minimum of MB of unpartitioned space at the end of the drive.